CONNECT TO THE GAS SUPPLY
The inlet to the cooker is ½" BSP internal situated at the rear right corner. Fit the bayonet connection.
This should be located so as to ensure that the flexible connector hose does not kink.
Under no circumstances should the flexible connector be allowed to come into contact with the vertical
oven flue tubes on the rear of the appliance.
Use a 900mm - 1125mm length of flexible connector.
Ensure that all pipework is of the correct rating for both size and temperature.
Flexible connections should comply with BS 669. Parts of the appliance likely to come into contact with
a flexible connector have a temperature rise of less than 70°C.
After installation, make sure all connections are gas sound.