Dataman S6 User Manual page 33

Status Description:
After connecting to the programmer, the LED is not illuminated.
Troubleshooting:
5 Check whether the driver is installed correctly (Windows Device Manager).
Check whether the programmer is connected using the supplied Y-type USB cable and
both USB connectors are plugged into the host PC.
Status Description:
After the computer connects to the programmer, the LED flashes twice then goes out.
Troubleshooting:
Check whether the Dataman control software is running.
6
Check whether the driver is installed correctly (Windows Device Manager).
Check whether the hosts USB Port is a USB 2.0 High Speed interface.
Status Description:
When the software displays the below warning message it means the power supplied by
the hosts USB port is not sufficient. Click "Cancel" to ignore the message and continue,
however this may lead to unreliable operation.
Troubleshooting:
Use the supplied Y-type USB cable and connect both USB connectors to the host PC.
Change to another USB port.
Connect the programmer through an external powered USB Hub. (5V/1A or above)
7
Dataman-S6 - User's Manual
30