Table of Contents
Advertisement
3-1 General IC Insertion (DIP package)
If the IC is in a DIP package it must be inserted into the programmers ZIF socket towards
the bottom, with the index mark towards the top. Pin 1 of the IC should be at the upper left
position as shown here.
3-2 Special IC Insertion via Adapter Socket (Special package)
When the IC is not in a DIP package you must use a suitable package adapter. If the
number of pins on the DIL header underneath the adapter is less than 48 then the adapter
should be placed into the ZIF socket towards the bottom as with standard DIP devices
above. The adapters are usually marked with a "1" to indicate the position of pin 1 on the
device. Place the IC into the adapter socket matching the position of pin 1.
Chapter 3 IC Insertion
8
Dataman-S6 - User's Manual
Advertisement
Table of Contents
