Jp6 Clear Cmos Data Jumper; Jp7 Ac'97 Codec Jumper; Jp8 Front Panel Usb (3/4) Device Power On Function - CHAINTECH CT-6SFV User Manual

Clear CMOS Data Jumper (JP6)
AC'97 CODEC Jumper (JP7)
Front Panel USB (3/4) Device Power On Function (JP8)
6sfv0-2.p65
1
Normal (default)
To clear the contents of the CMOS, please follow the
steps below.
1. Disconnect the system power supply from the power
source.
2. Set the jumper cap at location 2~3 for 5 seconds, then
set it back to the default position.
3. Connect the system's power and then start the system.
4. Enter BIOS's CMOS Setup Utility and choose Load
Setup Defaults. Type Y and press enter.
5. Set the system configuration in the Standard CMOS
Setup menu.
1
AC'97 CODEC Enabled
Short pin 1-2 to enable Soft Modem riser only (Onboard
AC`97 CODEC enabled). Short pin 2-3 to enable Soft
Audio Modem Riser.
1 Enabled 1
This board is able to be turned on by a USB keyboard
(hot key/Password). To use this function, select a device
of your choice at the Power on Function option in BIOS's
Integrated Peripherals screen. You must also set this
jumper's cap to pins 2-3 to use this function.
17
Hardware Setup
1
Clear CMOS data
1
Soft-Audio/Modem Riser Enabled
Disabled
2000/5/5, PM 04:04
17