Chapter 2
Optional Power On By Modem (JP4)
Clear CMOS Data Jumper (JP5)
Optional S/PDIF-Out Connector (J1)
14
1
Disble (default)
While in Soft-off state, if thel modem ring-up
signal occurs, the system wakes up and can be
remotely accessed. You may enable this function
by setting the jumper's cap to pin 2-3.
1
Normal (default)
To clear the contents of the CMOS, please follow
the steps below.
1. Disconnect the system power supply from the
power source.
2. Set the jumper cap at location 2~3 for 5 seconds,
then set it back to the default position.
3. Connect the system's power and then start the
system.
4. Enter BIOS's CMOS Setup Utility and choose
Load Setup Defaults. Type Y and press enter.
5. Set the system configuration in the Standard
CMOS Setup menu.
The S/PDIF-Out connector supports the digital
audio. This connector must be connected to the
cable from an external device. (Ex. 2-channel
decoded AC-3 from DVD decoders)
1
Enable
1
Clear CMOS Data