Fan; Jp1 Cmos Clear Jumper; Jp5 Keyboard Power On Function Jumper; Jp6 Disable/Enable Usb 0/1 Device Power On Jumper - CHAINTECH 7NIL1 User Manual

FAN 4 (North Bridge Cooling Fan Power)
The north bridge-cooling fan. The wiring and plug may vary depending on the
manufacturer. On standard fans, the red is positive (+12V), the black is ground.
JP1 (CMOS Clear Jumper):
There is a CMOS RAM on board that has a power supply from external battery to
keep the data and system configuration. To clear the contents of the CMOS, please
follow the steps below.
1. Disconnect the system power supply from the power source.
2. Set the jumper cap at location [2-3] for <5 seconds>, and then set it back to the
default position.
3. Connect the system's power and then start the system.
4. Enter BIOS's CMOS Setup Utility and choose Load Setup Defaults. Type [Y] and
then press [Enter] to continue.
5. Set the system configuration in the Standard CMOS Setup menu.
Chapter 2
Pin Definition
1-2 Normal (default)
2-3 Clear CMOS Data
13
Chapter 2
JP5 (Keyboard Power On Function Jumper):
Pin Definition
1-2 Disable (default)
2-3 Enable
This board can be turned on by the PS / 2 keyboard (hot key). To use this function,
select a hot key of your choice at the Power On Function option under Wake Up
Events in the BIOS's Power Management setup screen. You must also set this
jumper's cap to pins 2-3 to use this function.
JP6 (Enable/Disable USB 0/1 Device Power ON Jumper)
Pin Definition
1-2 Disable (default)
2-3 Enable
A USB keyboard hot key or a USB mouse click can turn on this motherboard. To
use this function, select [Enable] at the USB Resume from S3 under Wake Up
Events in the BIOS's Power Management setup screen. You must also set this
jumper's cap to pins [2-3] to use this function.
14