Feature Explanations Software Power-Off Control; Power-On By Modem; Jp2 Clear Cmos Data Jumper; Sysfan System Cooling Fan Connector - CHAINTECH 5AGM2 User Manual

Software Power-Off Control
This mainboard can be powered down using theWindows 95 Software Power-Off
function. To power down your computer, click the START button on the Windows 95
task bar. Select "Shut Down The Computer" and the system turns off. The message "It
is now safe to turn off your computer" will not be shown when using this function.

Power-On By Modem

While in Soft-off state, if an external modem ring-up signal occurs, the system turns
on and can be remotely accessed. Please enable the Power on by Modem function in
BIOS's Power Management menu to activate this function. (See Section 3-4)
CPU/System Cooling Fan Connectors (CPUFAN/SYSFAN)
CPUFAN
Clear CMOS Data Jumper (JP2)
SYSFAN
These added connectors allow the fans to draw their
power from the mainboard instead of the disk drive
connector. These fan connectors are available because
some systems have all the disk drive power connectors
in use.
1
Default
To clear the contents of the CMOS, please follow the
steps below.
1. Disconnect the system power supply from the power
source.
2. Set the jumper cap at location 2~3 for 5 seconds, then
set back to the default position.
3. Connect the system's power and then start the system.
4. Enter BIOS, load the setup default settings in the
CMOS Setup Utility Menu and then set the system
configuration in the Standard CMOS Setup menu.
Hardware Setup
1
Clear CMOS Data
11