Al Driver 1 (0-10V Or Dmx Control) - Acclaim Lighting Flex One Exterior Series User Manual

AL DRIVER 1 (0-10V OR DMX CONTROL)

This compact unit measures just 3.5" x 1.6" x 0.8" and provides dimming control for Flex One
tapes from either analog 0-10V (sink or source) or digital DMX control inputs. The AL Driver
1 unit requires a 24VDC power supply (such as the Acclaim Lighting APS-240-24) and can
drive up to three Flex One SO spools or one Flex One SO spool.
Dimming control by analog 0-10V (sink or source) input
AL Driver 1 unit
Power input
(24VDC 5A maximum)
Dimming control (and control daisy chaining) by DMX
Up to 32 AL Driver 1 units can be daisy chained on a single unbuffered DMX line. The final
unit in the daisy chain must be terminated by a 120Ω resistor across the Data + and –
output terminals.
AL Driver 1 units
DMX
input
(24VDC 5A max)
DMX
daisychain
to next unit
Power input
(24VDC 5A max)
Power input
www.acclaimlighting.com
0-10V
analog input
Up to three spools of Flex One SO (in
parallel, NOT daisy chained) or one
spool of Flex One HO tape can be
driven by a single AL Driver 1 unit.
Link cables require 2 cores. See cable
recommendations on page 13.
Up to three spools of Flex One SO (in
parallel, NOT daisy chained) or one
spool of Flex One HO tape can be
driven by a single AL Driver 1 unit.
Link cables require 2 cores. See cable
recommendations on page 13.
GND
0-10V IN
Stripe
+12-24V
Stripe
+12-24V
Clear
GND
Clear
GND
GND
0-10V IN
Stripe
+12-24V
Stripe
+12-24V
Clear
GND
Clear
GND
17