Matrix COSEC ARGO CAE200 Manual page 3

Pre-Installation Safety Instruction
1. Do not install the device in extremely hot temperature or under direct
Sunlight on turnstile or at extra bright places. This may affect the LCD
and finger print sensor of device. You can do indoor installation or on the
turnstile under the roof as shown in Figure 4.
Figure 4
2. You can mount the device on a flat surface such as a wall or near the
elevator, close to the access point (door) with surface wiring or concealed
wiring as shown in Figure 6.
3. Recommended height from ground level is upto 4.5 feet.
4. Do not install on unstable surfaces, near volatile inflammable materials,
areas where volatile gas is created, where ferromagnetic field or noise is
induced, where static is created, such as desks made of plastics, carpets.
5
5. Do not install the device in outdoor areas which may be exposed
to rain, cold and dust. You can do indoor installation or on the turnstile
under the roof as shown in Figure 5.
Figure 5
Figure 6
2
Next
Level
6