SolarEdge Inline Energy Meter Installation Manual page 36

Verifying the Meter Connection using SetApp When Connected via Energy
Net
To verify the inline meter connection using the SetApp Device Manager:
1. From the SetApp Commissioning menu, select Device Manager.
2. On the Device Manager page, select a specific meter (in case there is more than one
meter installed). The following information is displayed:
Meter Function: Displays the function performed by the inline meter.
Communication Type: The method of communication with the inverter - either
SolarEdge Energy Net (wireless) or RS485 (wired).
Serial Number: The serial number of the inline meter.
Power: The total power read by the meter.
Energy: The total energy read by the meter.
FW Version: The inline meter's firmware version.
Address: The SolarEdge Energy Net network address, or Modbus ID.
3. Select View Status to view meter status details:
Per phase: current, voltage, power
Total power and energy values
If the export/import metering function is in use, an arrow indicates the
instantaneous energy direction flow, per phase.
4. Additional options:
Remove Device: Select to delete the meter.
More Information: Select to receive additional operational guidance regarding
the meter.
Inline Energy Meter with SolarEdge Energy Net Communications
Chapter 3: Configuration 35