SolarEdge Inline Energy Meter Installation Manual page 32

Inline Meter Display Screen Operation
The inline meter supports initial meter configuration and operations using the meter's
display screen and push buttons. To change settings, unlock the meter using the "1231"
password. Supported operations include:
Factory reset. Resetting the meter's configuration parameters and energy counter to
factory default values.
The main screen displays export and import power readings, as shown in the figure
below.
Figure 18: Display Screen Export and Import Power Readings
MODBUS ID - This operation is used to set the inline meter's expected Modbus ID.
The Modbus ID should match the meter's Modbus ID as configured in SetApp.
Select RS485 Term to set the inline meter's RS485 termination (120 ohm) to ON or
OFF (default = ON).
Select Info to view the inline meter's firmware version.
The Inline Meter display screen automatically returns to the default Export/Import
Energy Values screen following 30 seconds of inactivity. When the default screen is
displayed, the display screen shuts down following 120 seconds of inactivity. Press any
key to light the display.
A guide to display screen navigation appears in the figure below.
Inline Energy Meter with SolarEdge Energy Net Communications
Chapter 3: Configuration 31