Hanging The Fan - Savoy House M2012 Series Owner's Manual

5. HANGING THE FAN

REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
Step 1. Remove the decorative canopy bottom
cover from the canopy by turning the cover
counter clockwise. (Fig. 5)
Step 2. Remove the hanger bracket from the
canopy by removing the 1 of 2 screws from the
bottom of the hanger bracket and loosening the
other one a half turn from the screw head. Next,
turn the canopy counter clockwise to removing
the hanger bracket from the canopy. (Fig. 5)
Step 3. Pass the 120-volt supply wires through
the center hole in the ceiling hanger bracket as
shown in Fig. 6.
Step 4. Secure the hanger bracket to the ceiling
outlet box with the screws and washers
provided with your outlet box.
Step 5. Remove the hanger pin, lock pin and set
screws from the top of the motor assembly.
Step 6. Route wires exiting from the top of
the fan motor through the collar cover, canopy
cover, canopy and then through the ball /
downrod. (Fig. 7)
Step 7. Align the holes at the bottom of the
downrod with the holes in the collar on top
of the motor housing (Fig.7). Carefully insert
the hanger pin through the holes in the collar
and downrod. Be careful not to jam the pin
against the wiring inside the downrod. Insert
the locking pin through the hole near the end
of the hanger pin until it snaps into its locked
position, as noted in the circle inset of Fig. 7.
Step 8. Tighten two set screws on top of the
fan motor firmly. (Fig. 7)
Step 9. Place the downrod ball into the hanger
bracket socket. (Fig. 8)
UL Listed
electrial box
Ceiling
hanger
bracket
Downrod
Coupling cover
Lock pin
Registration
slot
4
Hanger
bracket
Ceiling
canopy
Canopy
cover
Figure 5
Washers
Mounting screws
120V Wires
(supplied with
electrical box)
Figure 6
Canopy
Canopy cover
Set screws
Figure 7
Figure 8
Hitch pin