Table of Contents
Advertisement
7. FINISHING THE
INSTALLATION
Step 1. Tuck connections neatly into ceiling
outlet box.
Step 2. Slide the canopy up to hanger bracket
and place the key hole on the canopy over the
screw on the hanger bracket, turn canopy until it
locks in place at the narrow section of the key
holes.
Step 3. Align the circular hole on canopy with
the remaining hole on the hanger bracket,
secure by tightening the two set screws.
NOTE: Adjust the canopy screws as necessary
until the canopy and canopy cover are snug.
(Fig. 12)
WARNING: Make sure tab at bottom of hanger
bracket is properly seated in groove of hanger
ball before attaching canopy to bracket. Failure
to properly seat tab in groove could cause damage
to electrical wiring.
8. ATTACHING THE FAN
BLADES
Step 1. Align the holes in the blade, the blade
support plate, and the fan motor assembly and
secure with a blade attachment screws with
lock washers. (Fig. 13)
Outlet box
Hanger
bracket
Blade support plate
Screws with lock washers
6
Canopy
Canopy cover
Figure 12
Figure 13
Screws
Blade
Advertisement
Table of Contents
