Table of Contents
Advertisement
Resetting Custom Picture Files
1 Select a custom picture file (A 119).
> [/ Custom Picture] > [Edit / File] > [Reset].
2 Select
3 Select a preset custom picture setting and then select [OK].
• The custom picture file will be reset to the selected values.
Look Files
You can register 3D LUT files (.cube format) created with Blackmagic Design's DaVinci Resolve or other software
as Look Files in the custom picture file. Using a Look File allows you to adjust the video quality of the recorded
video. These adjustments apply also to proxy clips, photos, and screen/output terminals.
1 Insert the SD card with the desired Look File (.cube format, located in the root directory of the SD
card) into the camera's SD card slot B.
2 Select a custom picture file. (A 119)
/
3 Select
> [
Custom Picture] > [Edit
/
4 Select
> [
Custom Picture] > [Edit
• The Look Files in the SD card will be displayed.
5 Select the desired Look File.
6 Select the [Gamma/Color Space] setting to use after the Look File is applied.
7 Select [OK] twice.
• The selected Look File will be loaded and registered to the custom picture file.
• The image quality adjustments set in the Look File will be applied, and
• When disabling the image quality adjustments set in the Look File, select
[Edit / File] > [Look File] > [Off].
NOTES
About Look files
- The camera supports Look Files (.cube format) in 17 grid or 33 grid format created with Blackmagic
Design's DaVinci Resolve or other software.
- Look Files with input ranges outside the 0 to 1 range in the header ("LUT_3D_INPUT_RANGE") are not
supported.
- Look Files 2 MB and larger, as well as files with a name containing over 65 characters are not supported.
- Only the following characters can be used in the file name:
Numbers 0 to 9, upper/lower case letters a to z, underscore (_), hyphen (-), period (.) and a single byte
space.
• If the correct input/output gamma curve and color space conversion are not selected, video will not be output
correctly.
• A Look File cannot be used if the [Gamma/Color Space], [HLG Color] or [Over 100%] settings are changed
after registering it.
• When the gamma curve component of the [Gamma/Color Space] setting in the custom picture is set to either
[BT.709 Normal], [BT.709 Standard] or [BT.709 Wide DR], super-white (video signal above 100%) and super-
black (video signal below 0%) levels of brightness will be clipped. When the video signal contains super-white
brightness levels, select
[Press] and then activate the Look File to apply it to a signal compressed to 100%.
/
File] > [Gamma/Color Space] > Desired option.
/
File] > [Look File Setup] > [Register].
> [/ Custom Picture] > [Edit / File] > [Other Functions] > [Over 100%] >
Custom Picture Settings
will appear on the screen.
> [/ Custom Picture] >
121
Advertisement
Table of Contents
