Custom Picture Settings; Selecting Custom Picture Files; Preset Custom Picture - Canon XA60 Instruction Manual

Custom Picture Settings

Custom Picture Settings
The camcorder lets you change many settings (A 93) that control various aspects of the image
produced. As a set, all these settings are treated as a single custom picture file. After adjusting the
desired settings to your preference, you can save up to 6 custom picture files (in the camcorder or on
an SD card), and load them later to apply exactly the same settings (A 92). This function can only be
used when the shooting mode is set to ', ‚, ", or n.
90
Operating modes:

Selecting Custom Picture Files

You can adjust the image characteristics of the custom picture file selected. You can also rename,
protect or reset custom picture files. Be sure to remove the protection before editing a custom picture
file.
1 Enable the custom picture function and then select [X].
[v% Camera Setup]
2 Select a custom picture file.
>
[FUNC]
• Select the desired custom picture file.
• The settings in the custom picture file will be applied.

Preset Custom Picture

The following settings are saved to custom picture files C1 to C6 as preset custom picture settings.
Custom picture file C1 is protected by default and need to be unprotected before they can be edited.
C1: [Normal]
C2: [USER02] to
C6: [USER06]
NOTES
• To use the settings of a custom picture file saved on a card, copy the file to the camcorder in
advance (A 92).
• This function cannot be used when infrared recording is activated.
> >
[/ Function]
[Gamma/Color Space]
[BT.709 Normal / BT.709]
[BT.709 Normal / BT.709]
[i On]
[Color Matrix]
[Video] These settings are appropriate for playback
on a TV monitor.
[Video]
Description