Table of Contents
Advertisement
IP Streaming
In CAMERA mode, you can stream the camera's live video and audio over IP to a compatible IP video decoder*
connected to the network. You can use IP streaming for live broadcasts or to send video reports from a location
with poor network connectivity.
* This can be a dedicated video transfer device or decoder software on a computer. For details about compatible decoders,
please visit your local Canon website.
Configuration of video streamed over IP
Main recording video configuration
Video format
Resolution
XF-AVC,
3840x2160,
MP4 (H.264)
1920x1080
* When the audio of the primary clip uses 4 channels, you can select which channels to stream over IP.
1 On the receiver's side: Connect the decoder to the network and complete any necessary
configurations so it is ready to receive video over IP.
• For details refer to the instruction manual of the decoder device or software you will use.
2 On the camera: Connect the camera to the desired network and activate the network functions
A
(
160).
• Select a connection setting with the [IP Streaming] function setting.
3 Select
> [
• The camera will start streaming video over the selected network.
• You can press the REC button to simultaneously record the same image in the camera.
4 On the receiver's side: Only when the streaming protocol is [RTSP+RTP], access the following URL
and log in using the RTSP user name and password (A 163).
5 On the camera: To end the streaming, select
Streaming] > [Disable].
IMPORTANT
• Streamed data is not encrypted.
NOTES
• Except when the streaming protocol is [RTSP+RTP], once IP streaming is activated, the camera will continue
to broadcast video and audio data over the network, regardless of the status of the receiver. Be careful to set
up the correct IP address and test in advance that the receiving decoder can indeed receive the signals.
• Depending on the network used and the connection conditions, you may experience lost or delayed IP
packets.
• After streaming continuously for 24 hours, the camera will stop the IP streaming momentarily and then restart
it automatically.
• When using IP streaming together with the Browser Remote function, you may experience stuttering issues in
the streamed video or audio. When the two functions are used simultaneously, it is recommended not to log
out from/reconnect to Browser Remote.
Frame rate
Bit rate
59.94P
59.94i
9 Mbps,
4 Mbps,
50.00P
50.00i
Network Settings] > [Activate IP Streaming] > [Enable].
rtsp://xxx.xxx.xxx.xxx/stream
Camera's IP address
Streamed video configuration
Video
Resolution
Frame rate
59.94P, 59.94i
59.94i
1920x1080
50.00P, 50.00i
50.00i
> [
Network Settings] > [Activate IP
IP Streaming
Audio
Audio format
Bit rate
MPEG-2 AAC
256 Kbps
2 channels*
175
Advertisement
Table of Contents
