Interval Recording Mode - Canon XF605 Instruction Manual

Special Recording Modes
NOTES NOTES
• Frame recording cannot be used simultaneously with slow & fast motion recording, pre-recording, interval
recording or continuous recording.
108
• Frame recording cannot be used when the frame rate is set to 59.94i or 50.00i. When in use, frame recording
will end if the frame rate is set to 59.94i or 50.00i.
• The number of frames recorded cannot be changed while recording.
• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
• About the time code when frame recording is activated:
- The time code mode can be set to [Regen.], or to [Preset] with [Rec Run] running mode. The time code
advances by the number of frames recorded every time.
- If the time code running mode was set to [Free Run] or the camera was synchronized to an external time
code signal, the time code running mode will be changed automatically to [Rec Run] when frame recording
is activated.
- When the special recording mode is deactivated, the time code running mode will return to its previous
setting.
- The time code signal will not be output from the TIME CODE terminal, SDI OUT terminal or HDMI OUT
terminal.

Interval Recording Mode

Set the interval and number of frames in advance. Sound is not recorded in this mode.
You can also use direct touch control to perform this function (A 49).
1 Select > [Æ Recording/Media Setup] > [Recording Mode] > [Interval Recording].
• [INT STBY] appears at the top of the screen (with [INT] flashing).
2 Select > [Æ Recording/Media Setup] > [Interval Rec: Time Interval] > Desired option.
3 Select > [Æ Recording/Media Setup] > [Interval Rec: Frame Rate] > Desired option.
4 Press the REC button to begin recording.
• The tally lamp illuminates.
• [INT STBY] changes to [INT ÜREC] while recording.
• The camera automatically records the set number of frames at the specified interval.
5 Press the REC button again to stop recording.
• The tally lamp goes out and [INT STBY] appears at the top of the screen (with [INT] flashing).
6 Select > [Æ Recording/Media Setup] > [Recording Mode] > [Normal Recording] to stop interval
recording.
NOTES NOTES
• Interval recording cannot be used simultaneously with slow & fast motion recording, pre-recording, frame
recording or continuous recording.
• Interval recording cannot be used when the frame rate is set to 59.94i or 50.00i. When in use, interval
recording will end if the frame rate is set to 59.94i or 50.00i.
• The interval and the number of frames recorded cannot be changed while recording.
• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
• When the special recording mode is deactivated, the time code running mode will return to its previous setting.
• The time code signal will not be output from the TIME CODE terminal, SDI OUT terminal or HDMI OUT
terminal.