Trane MCC Series Owner's Manual page 22

Timer Operation
Once you select the timer operation, the settings
are saved in the remote control. Thereafter, the
air conditioner will start operating under the same
conditions when you simply push the POWER
button on remote control.
1. ON TIMER Setting
You can set ON TIMER to start the unit automatically
up to 24 hours.
Press TIMER button when unit is off operation,
display will show number of hours to be set for
TIMER in sequence of 1H
Cancel
Once TIMER is set, press TIMER button again to
cancel TIMER.
2. OFF TIMER Setting
You can set OFF TIMER to stop the unit automatically
up to 24 hours.
Press TIMER button when unit is in operation,
display will show number of hours to be set for
TIMER in sequence of 1H
Cancel
Once TIMER is set, press TIMER button again to
cancel TIMER.
SLEEP Mode
Sleep mode automatically and gradually adjusts
room temperature to provide great comfort during
your sleep.
Press SLEEP button,
"SLEEP" position on LCD display. After one
hour operation of SLEEP mode, the unit will
automatically raise set temperature by 1 °C. One
hour after that it will again raise set temperature
by 1 °C (while the set temperature shown on
remote control is still not changed). The unit will
be working at that setting temperature until SLEEP
Mode is cancelled or unit is turned off.
Press SLEEP button again to cancel this operation.
In case of power failure, changing in operation
mode, or turning off air conditioner, SLEEP mode
will be automatically cancelled.
8
MCC-SVU01A_En.indd 8 MCC-SVU01A_En.indd 8
Control Operation
2H 3H ... 24H
2H 3H ... 24H
indicator shows at
Hold Key
Hold key is used to lock the operation of key pad
of the remote control. Press Hold key to lock the
key pad. All the buttons except Hold key will be
inactive. Press this button again to active the key
pad buttons.
Notice for Operating Remote Control
Do not place the remote control near high heat
source.
Do not expose the remote control in the sun.
Take care for it and prevent it from damage for
falling down.
Do not place any rolling obstacle to between the
signal receiver of the unit and remote control,
otherwise it may affect sending or incepting the
signal.
Do not spray water or other liquid on remote
control.
Do not place any clog on the remote control.
When the remote control is out of order, try
replacing the battery and operating it again. If
the failure has not been solved, please take the
emergency button to stop the air conditioner and
contact the nearest Trane service center.
MCC-SVU01A
4/18/13 5:31:30 PM 4/18/13 5:31:30 PM