(including electrical data) to insure The Trane Company will not this manual. the proper unit was shipped. assume any responsibility for unit For installing the unit to operate...
Contents General Information Safety Precaution System Appearance Indoor Unit Installation Outdoor Unit and Remote Control Installation Drain Hose Installation Leak Check and System Evacuation Electric Wiring Wiring Diagram Dimensional Data MCC-SVN01A www.ttair.co.th | Tel : 02-385-0728 | E-mail : sales@ttair.co.th | LINE ID : @ttair...
System Precautions Please read and follow the instructions and Refrigerant R32 is environmentally friendly. warnings in the manual carefully before High cooling efficiency and ignite at low rates. installation or mantenance air conditioner. WARNING WARNING This symbol indicates the possibility of death or serious injury. Be sure to use the part provided or specified parts for the installation work.
System Appearance Indoor Unit Water Pump (Built-in) Drain Pipe Front Panel Air Outlet Return Air Air Filter (Inside) Air Outlet Display Lights High Pressure Remote Control Copper Tube Low Pressure Remote Control Holder Copper Tube Connection Wire between Indoor Unit & Outdoor Unit Refrigerant Tube Air Inlet Drain Pipe...
Indoor Unit Installation • • Where to Install Indoor Unit Hang the four mounting rods to the Install the leveling metal plate to positions marked as picture shown adjust the gap between the unit • There should not be any heat source in figure 3 (using twelve nuts and and a ceiling, fixing the screws or steam near the unit.
Outdoor Unit Installation More than 30 cm. Where to Install outdoor Unit • The foundation must be solid More than 30 cm. enough to bear the weight and ibration of the unit. • The space around the unit is More than 50 cm. adequate for ventilation.
Drain Hose Installation • The diameter of the drain hose should be equal to or bigger than the connection pipe’s. (The diameter of polythene pipe: Outer diameter 25mm wall thickness 1.5mm) • Drain hose should be short and drooping gradient should be at less 1/100 to prevent the formation of air bubble.
Page 25
Drain Hose Installation Drain hose (Accessory) Figure 9 • The slant gradient of the attached drain hose should be within 75mm so that the drain hole dosen’t has to endure the unnecessary outside force. • Check the smoothness of drain after installation. •...
Leak Check and System Evacuation • Leak Check Procedure Close valve on the R410A/R32 supply cylinder. Close valves on • After the connection operation of Connect R410A/R32 drum with gauge manifold gauge set and remove refrigerant lines to both the outdoor manifold to the Schrader valves refrigerant charging hosed from and indoor unit is completed, the...
Electric Wiring Requirement for grounding • Air conditioner is the Clase I electric appliance, so please do conduct reliable grounding measures. • The yellow-green two-color wiring of air conditioner is grounding wire and cannot be used for other purposes. It cannot be cut off and be fixed by screws, otherwise it would cause electric shock. •...
Page 32
For more information, please visit trane.com or tranetechnologies.com. Trane has a policy of continuous product and product data improvement and reserves the right to change design and specifications without notice. We are committed to using environmentally conscious print practices.