Page 2
About this Manual note, and send a registered letter of and liabilities by The Trane Company. Cautions appear at appropriate protest to the last carrier of the places in this Instruction Manual.
Contents General Information Control Operation Wireless Remote Control Digital Wired Control System Operation Safety Precautions Maintenance Troubleshooting MS-SVU0013-EN MS-SVU0013-EN.p65 20/7/2007, 11:51AM...
Control Operation Infrared Remote Control Unit Display and One-touch Control Switch Display Panel Four lamps on the unit show operating status. 1. FAN Lamp This lamp lights when the fan is operating. 2. COOLING Lamp This lamp lights when the unit is in COOL or DRY mode of operation.
Wireless Remote Control Infrared Remote Control Installation of Batteries 1. Slide the back cover of the remote control down to take it off. Name and function of buttons 2. Insert two dry batteries into the slot. Be sure that the + and – directions are 1.
Page 6
Wireless Remote Control Indicators on Infrared Remote Operation Mode DRY Mode Control - Press Mode button to select the operation mode. FAN Mode - “DRY” will be shown on the display - Press Mode button to select the when DRY mode is selected. operation mode.
Page 7
Wireless Remote Control Timer Operation • In case of power failure, ON TIMER will • Press CLOCK button to see present be automatically cancelled as there is time after ON/OFF TIMER was set. The Once you select the timer operation, the no electricity in the air-conditioner;...
Page 8
Wireless Remote Control SLEEP Mode FRONT BLADE Function ECONO MODE (COOLING) The unit will operate at low fan speed and raise temperature by 1ºC SLEEP mode automatically and gradually FRONT BLADE function offers you the from set temperature. It will automatically return to normal operation when the air-conditioner is switched off and on again.
Digital Wired Control Indicators on Digital Wired Operation Mode Name and function of buttons Control FAN Mode 1. Infrared Signal Receiver (op- - Press Mode button to select the tional) operation mode. Receives the signal from handheld will be shown on the display when remote control and transmits the signal FAN mode is selected.
Page 10
Digital Wired Control DRY Mode Timer Operation OFF TIMER Setting - Press Mode button to select the You can set OFF TIMER to start the unit Once you select the timer operation, the operation mode. automatically at any desired time up to settings are saved in the control.
Page 11
Digital Wired Control Note: SWEEP Function - When TURBO mode completely • Set temperature shown on the display operates or is cancelled, “TURBO” will SWEEP function swiftly distributes air flow still show the setting without 1ºC be disappeared from the display and and helps provide better air circulation in added/reduced but it will plus/minus return to the former settings before...
• Temperature setting is adjusted Trane dealer. control will automatically resume back and forth. its operation with the same setting • ON/OFF switch is turned ON...
Since the fan revolves at high speed, If you have any questions or it is very dangerous. Be especially problems with your air conditioning careful with children. system, please consult Trane dealer or The Trane Company. MS-SVU0013-EN MS-SVU0013-EN.p65 20/7/2007, 11:52AM...
Maintenance Regular Maintenance 2. Cleaning the front panel 1.2 How to clean the air filter Be sure to disconnect the power Do not pour water directly on the Wash away dust from the air before inspection or maintenance of front panel to clean it. Dust or filter with clean water or air conditioner.
Troubleshooting Before calling for service, please Cooling is insufficient: check the following. - Check whether the air filter is clogged. Clean it. The air conditioner does not - Check whether the thermostat operate at all: setting is too high. Set the - Check if the control ON/OFF thermostat to lower temperature.
Page 16
Bangkok, Thailand www.trane.com Trane has a policy of continuous product and product data improvement and reserves the right to For more information, contact your local district change design and specific ations without notice. Only qualified technicians should perform the installation office and servicing of equipment referred to in this publication.
Need help?
Do you have a question about the NEW STYLUS MCX 512 GB and is the answer not in the manual?
Questions and answers