Introduction - Agilent Technologies E5505A Installation Manual

1
General Information

Introduction

Use this guide to unpack, connect instruments (if needed), power on,
configure, test, and power off your Agilent E5505A Phase Noise
Measurement System. For all system models, start with the information in
this chapter—especially the unpacking guidelines starting on
If you've ordered a racked system, it arrives as a turnkey solution—ready
to power on with all hardware and software installed. If you've ordered a
flat- panel display, procedures for mounting it are in
powering on procedures in
measurement.
A benchtop system arrives with all hardware and software installed, but
you must connect the instruments with the appropriate cables. You'll find
instrument connection diagrams in
cables with the system.) Then proceed to
system and make your first measurement.
If you need to re-install the phase noise hardware and software in the E5505A system PC
N O T E
for any reason, refer to the E5505A Phase Noise Measurement System User's Guide for
information and procedures.
Use
• Racked system
• Benchtop system
Table 1
Rack
Chapter
Chapter
Chapter
Appendix
Information"
8
Table 1 as a guide to the chapters to use for your model:
E5505A installation reading road map
1, "General Information"
2, "Flat-Panel Display" (if applicable)
4, "Measurement Software"
A, "Service, Support, and Safety
Chapter 4 and you're ready to make your first
Chapter 3. (Agilent ships the needed
Chapter 4
Benchtop
Chapter 1, "General Information"
Chapter 3, "System Interconnections"
Chapter 4, "Measurement Software"
Appendix A, "Service, Support, and Safety
Information"
page 10.
Chapter 2. Follow the
to power on your
E5505A Installation Guide