Table of Contents
Advertisement
Half-Rack-Width instrument
To install the instrument in a rack
Step
1 Make sure the system is powered off.
2 Re-attach the lock link that secures the front
3 Re-attach the lock link that secures the rear
4 Insert the attached instruments in the same
5 Replace the rack panel in front of the
6 Confirm that the instrument is turned off.
7 Connect the appropriate cables to the
8 Power on the system.
Benchtop instrument
To install an instrument in a benchtop system
1 Make sure the system is powered off.
2 Connect all cables to the instrument (front
3 Connect the power cord to the AC power
4 Power on the system.
5 Set the instrument GPIB address, if
E5505A Installation Guide
of the returned instrument to it's partner
half-rack-width instrument.
of the instruments together.
slot from which you removed them, sliding
them along the support rails until they meet
the rack-mount ears.
instruments and secure the four corner
screws.
instruments (front and rear), including the
power cords.
and rear), including the power cord.
source.
necessary.
Preventive Maintenance
Note
•
For details, see
"Powering the System
Off"
on page 56.
•
Use a #2 POZIDRIV screwdriver.
•
See
Figure 42
on page 81.
•
Use a #2 POZIDRIV screwdriver.
•
The rack-mount ears stop the instruments at
the correct depth.
•
The screws are located near the corners of
the face of the instrument.
•
Use a #2 Phillips screwdriver.
•
For details, see
"Powering the System
On"
on page 32.
•
For details, see
"Powering the System
Off"
on page 56.
•
For details, see
"Powering the System
On"
on page 32.
6
83
Advertisement
Table of Contents
