ESAB CIGWELD EasyWeld 130 Operating Manual page 44

EasyWeld / HandyWeld 130
MIG Gun
Figure 5-18: Setup for MIG Welding with Gas Shielded MIG Wire
Select MIG Gas (Solid) Mode using the Process Selection Control button. (refer to section 4.02.1 for further
information).
Figure 5-19: Select MIG Gas Mode
Figure 5-20: Select Welding Wire Diameter
NOTE!
Quick Set wire sizes for MIG GAS (Solid Wire) are
0.6mm and 0.8mm diameter.
MIG (GMAW) WELDING
230/240 VAC
10A
Mains Supply
Negative Welding Terminal (-)
MIG
Positive Welding Terminal (+)
Polarity
Lead
Work Lead
5-12
Gas Hose
Preset Argon Regulator
Preset Argon Regulator
Shielding
Gas Cylinder
Shielding Gas Hose
Supply Input Lead
Figure 5-21: Select Plate (Material) Thickness
At this point the desired Quick Set settings have
been set and the unit is ready for Welding. Once
the Welding Arc is established the display will
show the Welding Current.
If the user wishes to adjust the Quick Set settings
outside of the factory settings, the following steps
are available.
Wire Feed Speed Control (WFS / AMPS) adjustment
Figure 5-22: Select Wire Feed Speed Control
Gas Inlet Connection
Art # A-14852
Manual 0-5618