ESAB CIGWELD EasyWeld 130 Operating Manual page 41

Select MIG Gasless Mode using the Process Selection Control button. (refer to section 4.02.1 for further
information).
Figure 5-12: Select MIG Gasless Mode
Figure 5-13: Select Welding Wire Diameter
NOTE!
Quick Set wire sizes for MIG GASLESS (Flux Cored
Wire) are 0.8mm and 0.9mm diameter.
Manual 0-5618
MIG Gun
Figure 5-11: Setup for MIG Welding with Gasless MIG Wire
EasyWeld / HandyWeld 130
Negative Welding Terminal (-)
Positive Welding Terminal (+)
MIG
Polarity
Lead
Work Lead
Figure 5-14: Select Plate (Material) Thickness
At this point the desired Quick Set settings have
been set and the unit is ready for Welding. Once
the Welding Arc is established the display will
show the Welding Current.
If the user wishes to adjust the Quick Set settings
outside of the factory settings, the following steps
are available.
Wire Feed Speed Control (WFS / AMPS) adjustment
Figure 5-15: Select Wire Feed Speed Control
5-9
230/240 VAC
10A
Mains Supply
Art # A-14851
MIG (GMAW) WELDING