Maintenance; Display - Bosch Rexroth IndraControl VDP 15.3 Multi Touch Operating Instructions Manual

Bosch Rexroth AG

Maintenance

Errors
No image visible
Distorted display due to incorrect dis-
play resolution
The USB flash drive does not work, al-
though other USB devices work
USB devices and touch screen do not
work
Limited operability of the operator dis-
play
Tab. 13-1: Error causes and troubleshooting
Repairs at the device by the customer are not permitted. Exceptions
are maintenance works listed in the chapter "Maintenance".
For further information in the event of repair, please contact the
Bosch Rexroth Service.
14 Maintenance
NOTICE
Ensure that the IP degree of protection remains during maintenance!
Only the maintenance works at the device listed in this chapter are
permitted.
For further information in the event of repair, please contact the
Bosch Rexroth Service.

14.1 Display

The backlight is subject to wear, see
30/37
Troubleshooting
Connect the supply voltage and check the X1S1 connec-
●
tion
Connect the CDI cable correctly and check XVID and
●
XSER
Set the image output in the graphics driver to "VDP"
●
Switch on the voltage at the operator display before or
●
with the control cabinet PC
Set the correct display resolution in the graphics driver
●
Restart the control cabinet PC
●
Set the DIP switch on the VDP to <30 m
●
Note: USB memory sticks can only be used up to a cable
●
length of 30 meters
Set the DIP switch appropriately to the cable length
●
Avoid strong high-frequency interferences close to the
●
operator display
Loss of IP degree of protection due to incorrect
maintenance.
chapter 5.6 "Wear parts" on page
DOK-SUPPL*-VDPXX.3MTBU-IT03-EN-P
8.