Bosch Rexroth IndraControl VDP 15.3 Multi Touch Operating Instructions Manual page 25

Loss of degree of protection IP 65!
The housing, in which the operator display is installed, has to fulfill
the following conditions:
Free from impurities
●
Sufficient mechanical strength and flatness
●
These criteria influence the required IP degree of protection to a
great extent.
Further required measures have to be taken depending on the
mounting location, e. g. the stabilization of the mounting frame.
1. Prepare a mounting cut-out, refer to
tions in millimeters" on page
2. Insert the operator display from the front into the cut-out until the latching
lug at the top of the device latches in the cut-out.
①
Clamp fastenings
②
Latching lug
Fig. 10-4: Position of clamp fastenings
3. Fold out the clamp fastenings.
DOK-SUPPL*-VDPXX.3MTBU-IT03-EN-P
Mounting, demounting and electric installation
fig. 10-6 "Mounting cut-out, specifica-
21.
1 2
Bosch Rexroth AG
19/37