Maintenance; General Information; Display; Cleaning Notes - Bosch Rexroth IndraControl VDP 15.3 Operating Instructions Manual

VDP 15.3, 18.3, 21.3 Multitouch
Error
No image visible
Distorted display due to incorrect dis-
play resolution
The USB flash drive does not function,
although other USB devices function
USB devices and touch screen do not
work
Tab. 13-1: Error causes and error elimination

14 Maintenance

14.1 General Information

NOTICE
The IP degree of protection must be ensured during maintenance!

14.2 Display

The backlight is subject to wear, see
A fading backlight causes a progressive deterioration display readability, so that
a replacement is necessary. For further information please contact the Bosch
Rexroth Service.

14.3 Cleaning Notes

NOTICE
Do not use solvents.
●
Do not use high pressure cleaning devices.
●
DOK-SUPPL*-VDPXX.3MTBU-IT02-EN-P
Correction
Connect the supply voltage, check the X1S1 connection
●
Connect the CDI cable correctly, check XVID and XSER
●
Set the screen output in the graphics driver to "VDP"
●
Switch on the voltage at the VDP before or at the same
●
time as the control cabinet PC
Set the correct display resolution in the graphics driver
●
Restart the control cabinet PC
●
Set the DIP switch on the VDP to <30 m
●
Note: USB flash drives can only be used up to a cable
●
length of 30 meters
Set the DIP switch according to the cable length.
●
Loss of IP degree of protection due to incorrect
maintenance.
chapter 5.5 "Wear Parts" on page
Disintegrating of face-plate sealing due to sol-
vent!
Bosch Rexroth AG
Maintenance
7.
29/37