Storage; Overview; Storing The Machine After Operation; Installation - Wega ALE Use And Maintenance Manual

4. STORAGE

4.1 Overview

In the waiting period prior to installation, the machine must
be stored by the Manufacturer or an Authorised Distributor.

4.2 Storing the machine after operation

If the machine is not used after a certain period of time, store
it in the following conditions:
• Disconnect the machine from the water and power mains.
• Empty all the internal circuits of water.
Store the machine taking the following precautions:
• Store in a closed environment.
• Protect it from shocks and stresses.
• Avoid contact with corrosive substances.
The machine was designed and built to operate in environ-
ments with the following characteristics:
• Room temperature:
• Max. relative humidity:
Any variation in these characteristics may decrease the aver-
age life of some of the machine's components. Typical exam-
ples:
• Room temperature: premature degrading of the motors.
• Relative humidity: premature degrading of seals and elec-
tronics.
If the environmental features are significantly
different than those listed, contact the MANU-
FACTURER before they become a potential
problem.
Before starting the machine up after it has
been placed in storage, the equipment must be
fully inspected.
22 100
of
+5°C - +35°C
50% (at 40°C)

5. INSTALLATION

5.1 Safety precautions

Carefully read the instructions provided in
chapter "I. SAFETY PRECAUTIONS" on page
3.
If the technician has not performed all the in-
stallation operations and the machine is then
used, this may result in serious damage to the
appliance and people.
If any work is carried out on the machine elec-
tronics when the machine is still live, any guar-
antee will automatically be invalidated.

5.2 PPE features

When installing the machine, the following PPE is required:
The use of protective gloves is mandatory.
The use of eye protection is mandatory.
The use of safety shoes is mandatory.

5.3 Environmental conditions

Room temperature
5.3.1
The electrical and electronic equipment that has been in-
stalled on the machine, has been designed and made to
function properly in environments where the temperature is
between +5 and +35°C.
Relative humidity
5.3.2
The electrical and electronic equipment that has been in-
stalled on the machine, has been designed and made to func-
tion properly in environments where the relative humidity
does not exceed 50% at a temperature of 40°C, or 90% at a
temperature of 20°C.
5.3.3 Altitude
The altitude of the installation site must not exceed 2000 m.
TECHNICIANS' manual