Dispensing Cappuccinos (Optional); Cup Warmer - Wega ALE Use And Maintenance Manual

• Place the jug under the hot water nozzle.
• Press the button for at least 5 seconds, until all the
dose button LEDs are lit.
• Press the hot water-dispensing button (Y) and wait for the
hot water to be dispensed.
• When the desired amount of water has been reached,
press the button again to confirm the dose.
• Once the programming is complete, return the program-
ming lever (X) - see note (*) - to the OFF position.
NOTE (*)
• In some models the programming lever (X) is not fitted;
to enter the programming mode, press and hold the
button for at least 5 seconds and all the pushbutton panel
LEDs should light up. To confirm the dose, press the
button.
• In other models, to access programming it is necessary to
use a special key switch.
• To exit the programming mode, simply wait a few seconds.

6.11 Dispensing cappuccinos (optional)

• Put the suction tube in the milk.
• Place the jug under the spout of the
cappuccino maker.
• Open the steam valve and when the
desired amount has been obtained,
close the steam valve.
• Pour the frothed milk into the cups
with the coffee.
To obtain hot non-frothed milk,
lift the cappuccino maker flap
upwards.
For better results, we suggest that you do
not dispense directly into the coffee cup,
but into a jug or pot, and then pour the
frothed milk on top the coffee.
Be sure to constantly keep the cappuccino maker clean, by fol-
lowing the instructions provided in paragraph XX.
TECHNICIANS' manual

6.12 Cup warmer

For safety reasons, we do not recommend plac-
ing cloths or other objects on the cup warmer
shelf in order to prevent the machine from over-
heating.
HIGH TEMPERATURE HAZARD: the cup warmer
can reach temperatures that may cause burns.
Be very careful.
The cup warmer temperature can be set according to personal
requirements. The procedure for activating and adjusting the
cup warmer according to the model in your possession, is de-
scribed below.
6.12.1 "ALE - EMA - EPU" versions
To use the cup warmer on this version of the machine, pro-
ceed as follows:
• Place the cups on the cup warmer (1) shelf of the coffee
machine.
• Turn the cup warmer switch (2) to the ON position.
A
To adjust the cup warmer temperature, proceed as follows:
• Remove the cup holder grille and drip tray.
• Turn the thermostat (A) to adjust the temperature or dis-
able the cup warmer. The cup warmer temperature will be
proportional to the value indicated on the thermostat.
Thermostat value
0
30
60
90
1
2
Cup warmer adjustment
Cup warmer OFF
Minimum temperature
Average temperature
Maximum temperature
39 100
of