Wiring - Pilz PIT si3.1 Operating Manual

PIT si3.1
[1]
Fig.: Preparing for installation, mounting foot dimensions and conduit pipe
Attaching the conduit pipe to the mounting foot:
Cut the conduit pipe [3] to the required length (minimum length: 60 mm).
}
Insert the O-ring gasket on to the mounting foot's pipe entry point.
}
Fit the conduit pipe to the mounting foot. Use the safety screw to secure the conduit
}
pipe from underneath the mounting foot.
Attach the connection unit to the mounting foot:
Separate the light elements from the connection unit. The light elements are fastened
}
via bayonet connections.
Place the connection unit on to the conduit pipe and attach the connection unit using
}
the cross head screw [7].
Attach the connection cable for the light elements:
Guide the connection cable for the light elements through the conduit pipe [3] and
}
through the cable feed in the mounting foot.
Refer to the diagram "Wiring the connection unit and assembling the light elements" for
}
details of how to wire the light elements.

Wiring

Operating Manual PIT si3.1
21864-EN-03
[2]
CAUTION!
Press down firmly when tightening the screw!
CAUTION!
Wire the indicator light unit when it is isolated from the power supply.
[3]
Flat gasket
7