Electrical Safety Guidelines - Nokia ONT Product Manual

ANSI ONT safety guidelines

Electrical safety guidelines

Figure 4-6 Sample laser product safety label on the ONT equipment
4.3.3 Transmit optical output
The maximum transmit optical output of an ONT is +5 dBm.
4.3.4 Normal laser operation
In normal operation, fiber cable laser radiation is always off until it receives signal from the line
terminal card.
Operating personnel must observe the instructions on the laser explanatory label before plugging in
the optical module.
DANGER
Hazard
Risk of eye damage by laser radiation.
4.3.5 Location class
Use cable supports and guides to protect the receptacles from strain.
4.4 Electrical safety guidelines
This section provides the electrical safety guidelines for the ONT equipment.
Note: The ONTs comply with the U.S. National Electrical Code. However, local electrical
authorities have jurisdiction when there are differences between the local and U.S. standards.
38
3FE55851ABAA
MAC:XXXXXXXXXXXX
SN:ALCLXXXXXXXX
CLASS 1 LASER PRODUCT
FCC ID: XXXXXXXXXXX
PRODUIT LASER DE CLASSE 1
This device complies with Part 15 of the FCC Rule.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
12VDC 3A
including intereference that may cause undesired operation.
ASSEMBLED IN CHINA
DANGER - Invisible Laser radiation when open.
2301 Sugar Bush Rd. AVOID DIRECT EXPOSURE TO BEAM.
DANGER - Rayonnement Laser invisible lorsqu'elle
Raleigh, NC 27612
est ouverte. Evitee l'expostion direct au faisceau.
Complies with 21 CFR 1040.10 and 1040.11 except for deviations
pursuant to Laser Notice No. 50 dated June 24, 2007
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-49348-AAAA-TCZZA
Model:
MFG:
MONTH: XX
YEAR: XXXX
ICS: XX
MRev: XX
I.T.E
Intertek
4006119
Nokia ONT
18532
December 2020
Issue 1