Files That Can Be Projected By The Cardplayer - Epson EasyMP EMP-735 Operation Manual

Files that Can be Projected by the CardPlayer

The following files can be projected using CardPlayer.
Type
Scenario
Graphics
Movie
DPOF
Tip :
• JPEG files with the extension ".jpeg" and MPEG files with the extension ".mpeg"
cannot be projected.
• Regarding projecting JPEG files, the image will not be projected clearly if compression
is set too high.
Downloaded from:
File Type
(Extension)
.sit
.bmp
.jpg
.png
.mpg
.mrk
http://www.usersmanualguide.com/
These are scenario files created by sending scenarios.
Also plays audio (.wav) files set as BGM at the time of
scenario creation.
Scenarios created in EMP SlideMaker included with
the EMP-735 and the EMP-715/505 can also be
played.
Only 24-bit colour files can be played.
Any version. However, projection is not possible for
CMYK colour formats, progressive formats, and items
with a resolution in excess of 2560 × 1920.
Projection is not possible for items with a resolution in
excess of 1024 × 768.
MPEG2-PS.
If the movie exceeds a maximum size of 720 × 480, or
is not in the same form as a DVD (sequence header
arranged for each GOP) it cannot be played back. The
reproducible audio format is MPEG-1 Layer 2. Linear
PCM and AC-3 audio cannot be played back. It is
recommended that memory cards used be of the
CompactFlash format, or a card type hard disk drive.
Correct reproduction may not be possible if using
memory cards other than those mentioned above.
Additionally, if a CompactFlash card with a slow
access speed is used, correct reproduction may not be
possible and the audio track may skip or cut out.
Depending on the contents, the screen or the sound
may be disturbed.
For DPOF version 1.10, only files named
AUTPLAYx.mrk (where x is a number between 0-9)
can be projected.
19
EasyMP Operation Guide
Notes