Mail Notification Settings; If A Problem Notification Is Sent By Mail - Epson EasyMP EMP-735 Operation Manual

Setting, Monitoring and Controlling from a Computer

Mail Notification Settings

Mail notification settings are made on the mail screen of the Network Screen
Access point mode advanced settings screen, or the Wired LAN connection
advanced settings screen. s "Connecting in Access Point Mode or Wired LAN
Connection Mode" in the EasyMP Setup Guide

If a Problem Notification is Sent by Mail

If an e-mail message with "EPSON Projector" in the subject line is sent to the IP
addresses that have been set as mail notification destinations, the message is a
notification message saying that there is a problem with the projector.
The following information will be contained in the body of the message.
Line 1 : The name of the projector where the problem has occurred
Line 2 : The IP address that has been set for the projector where the problem has
Line 3 : Details of the problem
The details of the problem are listed on separate lines. The following table shows
the details that are given in the message for each item.
Message*/Cause
Internal error
Fan related error
Sensor error
Lamp cover is open.
Lamp timer failure
Lamp out
Internal temperature
error
High-speed cooling in
progress
Lamp replacement
notification
No-signal
*A (+) or (–) will be appended to the start of the message.
(+): When a projector problem has occurred
(–): When a projector problem has been solved
Downloaded from:
occurred
http://www.usersmanualguide.com/
Remedy
"Using the Indicators" in the User's Guide.
No video signals are being input to the projector.
Check the connection status or check that the
power for the signal source is turned on.
48
EasyMP Operation Guide