Files That Can Be Projected By The Cardplayer - Epson EMP-7850 Operation Manual

Files that Can be Projected by the CardPlayer

The following files can be projected using CardPlayer.
File Type
Type
(Extension)
Scenario .sit
Graphics .bmp
.jpg
.png
Notes
These are scenario files created by
sending scenarios.
Also plays audio (.wav) files set as BGM
at the time of scenario creation.
Scenarios created in EMP SlideMaker
included with the EMP-735 and the
EMP-715/505 can also be played.
Only 24-bit colour files can be played.
Any version. However, projection is not
possible for CMYK colour formats,
progressive formats, and items with a
resolution in excess of 2560 × 1920.
Projection is not possible for items with a
resolution in excess of 2560 × 1920.
Movie .mpg
g
DPOF .mrk
TIP
JPEG files with the extension ".jpeg" and MPEG files with the extension
•
".mpeg" cannot be projected.
Regarding projecting JPEG files, the image will not be projected clearly if
•
compression is set too high.
EasyMP Operation Guide
MPEG2-PS.
If the movie exceeds a maximum size of
720 × 480, or is not in the same form as a
DVD (sequence header arranged for each
GOP) it cannot be played back. The
reproducible audio format is MPEG-1
Layer 2. Linear PCM and AC-3 audio
cannot be played back. It is
recommended that memory cards used be
of the CompactFlash format, or a card
type hard disk drive. Correct
reproduction may not be possible if using
memory cards other than those
mentioned above. Additionally, if a
CompactFlash card with a slow access
speed is used, correct reproduction may
not be possible and the audio track may
skip or cut out.
For DPOF version 1.10, only files named
AUTPLAYx.mrk (where x is a number
between 0-9) can be projected.
15