Table of Contents
Advertisement
6.2 Address Setting
If you use a universal DMX controller to control the units, you have to set DMX address from 1 to
512 so that the units can receive DMX signal.
Press the MENU button to enter menu mode, select DMX Functions, press the ENTER button to
confirm, use the UP/DOWN button to select DMX Address, press the ENTER button to confirm, the
present address will blink on the display, use the UP/DOWN button to adjust the address from 001
to 512, press the ENTER button to store. Press the MENU button back to the last menu or let the
unit idle 30 seconds to exit menu mode.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel mode
17 channels
20 channels
6.3 DMX512 Configuration
Please refer to below configurations to control the fixtures
Attentions:
1. The unit will maintain the last condition until reset if you cut-off the DMX signal.
2. For the channel Function, keep the value for about 3 seconds, then the corresponding function
will take into effect.
17 Channels (Mode 1):
CHANNEL
1
2
3
4
Unit 1
Unit 2
Address
Address
1
1
VALUE
000-255
000-255
000-255
000-015
016-063
064-127
128-191
17E
Unit 3
Address
18
35
21
41
FUNCTION
PAN
0°540°
TILT
0°270°
PAN/TILT SPEED
Fast to Slow
SHOW MODE
Null
Show 1
Show 2
Show 3
Unit 4
Address
52
61
Advertisement
Table of Contents
