Table of Contents
Advertisement
Settings
When you click on "Settings", the Trigger Channel tab
will appear (only for motion detection):
Select one or more camera channel(s) to react in the
event of an alarm.
Confirm the settings by clicking on Apply and exit the
menu by clicking on OK.
Arming Schedule
Select the Arming Schedule tab.
Here you set the times at which the reactions set in the
Linkage Action tab are triggered.
1.
Select the day and enter the schedule.
39
Note
Up to eight time slots, between 00:00 and 00:00,
can be defined in each case, but the individual
time slots must not overlap.
2.
Under Copy, select whether or not the setting should
be applied to every day of the week and the holiday
settings.
3.
Confirm the settings by clicking on Apply and exit
the menu by clicking on OK.
Linkage Method
Select the Linkage Action tab.
Here you can configure the response of the recorder in the
event of an alarm by ticking the corresponding box.
Parameter
Full Screen Monitoring
Audible Warning
Notify Surveillance Cen-
tre
Send Email
Trigger Alarm Output
Confirm the settings by clicking on Apply and exit
the menu by clicking on OK.
Camera
Notifications
The camera is displayed in
full screen in live view.
The device emits a repeated
signal tone.
The CMS sends out a warn-
ing message
An email is sent to a speci-
fied email address. See
page 29.
The alarm output is triggered
in the event of an alarm.
Advertisement
Table of Contents
