Selection Bar In The Camera Image; Settings - Abus TVVR35002 User Manual

Live view
Aux Monitor Switches the mouse control to the
AUX monitor
Note
Start Auto-switch:
Specify the display sequence delay in the display

settings.

Note
Activation of "AUX monitor" without a connected
spot monitor:
Mouse pointer function is disabled.

Selection bar in the camera image

In single or multi-screen, click on a camera image. A se-
lection bar will appear:
(0) (1) (2) (3) (4) (5) (6) (7)
No. Meaning of the symbol
(0) Area for moving the miniature bar
(1) Activate/deactivate manual recording
(2) Instant playback of the last 5 minutes
(3) Activate / deactivate the audio function
(4) Create a snapshot from the current camera
Open the PTZ control menu (for PTZ cameras
(5)
only)
(6) Digital zoom
(7) Image display settings
(8) Face Detection
(9) Live View Strategy
(10) Stream information
(11) Close the selection bar
Settings
Note
The following settings are available for the live
view.
Open the main menu and click on Configuration. Then
click on Live View:
15
The following settings are available in the General tab:
(8) (9) (10) (11)
Video Output In- VGA/HDMI
terface
Select the connection where the set-
tings are changed.
Live View Various camera layouts
Mode
1x1, 2x2, 1+5.
Dwell Time Switching time between the individ-
ual cameras during auto-switch.
Enable Audio Activates the audio output
(VGA/HDMI/BNC) for the live view.
Output
Display status Activate/deactivate the status bar.
bar
Volume Adjust volume
Event Output Allocate monitor for the output of
events.
Full Screen Moni- The number of seconds for which
the event will be displayed on the al-
toring Dwell Time
located monitor.
Post Event Dis- The number of seconds for which
the pop-up window should be dis-
play Time
played in the event of an alarm.
Note
VGA monitor connected:
If a VGA monitor is connected, it will be recog-
nised automatically when the device is started up.
The main video signal will be displayed on the
monitor.
No HDMI monitor connected:
If no HDMI cable is connected to the monitor
when the device is started up, the main video sig-
nal will be emitted at the main VGA connection.
Connect the VGA cable and restart the recorder to
perform automatic detection.