Installing The X-Npms In A Cabinet (Optional) - Honeywell X-618 Installation Manual

2. Put the DCS into the cabinet and fasten it with screws.
3. Install the side brackets of X-NRI and follow above steps to install in cabinet.
4. Install the side brackets of DA and follow above steps to install in cabinet.
5. Finally fasten them to the cabinet with screws.

Installing the X-NPMS in a Cabinet (Optional)

X-NPMS Configurable Network Paging Console and extend key module X-K4 or X-K8 can be
installed in the cabinet according to customer's requirements. Before installation, X-NPMS and
extend key module should be installed together first.
The process is described in the following steps:
1. Put the bottom of X-NPMS, extend key module X-K4 and X-K8 up on the clean desk, and
avoid scratch from the sharp items.
2. Use flat cables to connect the devices. Pay attention to the direction.
3. Put the bracket among the devices as shown in below figure, and fix it with standard
configuration screws.
Figure 6 Schematic Diagram of the DCS Bracket Installation
9