Connecting Da Main And Standby Power Supply Cables; Connecting Npm Power Supply Cable - Honeywell X-618 Installation Manual

Figure 24 Schematic Diagram of the NRI Standby Power Supply Cable Connection

Connecting DA Main and Standby Power Supply Cables

Connecting the Main Power Supply Cable
1. Strip off the wire jacket of one end of the prepared standby power supply cable by 20mm and
connect the cable to the main power supply wiring terminal.
2. Tighten the screws to prevent the power supply cable from coming loose, and cover the power
supply interface set.
3. Insert the wiring terminal of the installed power supply cable into the main power supply input
port of the DA, and tighten the screws at both ends.
4. Insert the other end of the main power supply cable into the main power supply equipment.
Connecting the Standby Power Supply Cable
1. Strip off the wire jacket of one end of the prepared standby power supply cable by 20mm and
connect the cable to the standby power supply wiring terminal.
2. Tighten the screws to prevent the power supply cable from coming loose, and cover the power
supply interface set.
3. Insert the wiring terminal of the installed power supply cable into the standby power supply
input port of the DA, and tighten the screws at both ends.
4. Insert the other end of the standby power supply cable into the standby power supply
equipment, such as the Uninterrupted Power Supply (UPS).
5. When there is not a standby power supply, main and standby power supply can be connected
to each other according to requirements.

Connecting NPM Power Supply Cable

Connecting Power Adapter
X-NPMS can be powered by power adapter. Insert one end of the power supply adapter into the
device power supply input port, and connect the other end of the power supply adapter cable to the
power supply equipment.
21