Connecting The Loudspeakers - Honeywell X-618 Installation Manual

Figure 20 Schematic Diagram of the X-DCS3000 Connecting to Noise Detector Connection
Note:
Each DCL bus can be connected with up to 5 digital noise detectors.

Connecting the Loudspeakers

The DCS can be directly connected to loudspeakers. The following steps describe this process:
1. Strip off the wire jacket of one end of the prepared audio cable by about 10mm, insert the
loudspeaker wiring terminal, and tighten the screws.
2. Insert the loudspeaker wiring terminal of the installed audio cable into the DCS loudspeaker
port.
3. Connect the loudspeaker to the other end of the audio cable, and if there are many speakers
in a same line, please follow the connection way shown in below figure.
Figure 21 Schematic Diagram of the Loudspeaker and Audio Cable Connection
18