Packing List Inspection; System Installation; Installing The Npm On A Fixed Surface (Optional) - Honeywell X-618 Installation Manual

Packing List Inspection

Please check the external packages for intactness before unpacking them for content inspection.
Use the "Packing list" to check the package contents. Contact the carrier or supplier promptly in
case of any package or package content problems.

3 System Installation

This chapter describes the system equipment installation, cable connections, and relevant
precautions.


Installing the NPM on a Fixed Surface (Optional)


Connecting the Protective Grounding Cabinet Wires

Installing the DCS and DA in the Appliance Cabinet

Connecting the Protective Grounding

Connecting the X-618 System Components

Connecting the Power Supply
Note:
The electricity and power sources must be turned off when performing the following tasks to avoid
electric shocks and damage to the equipment.
Turn off all equipment power supply switches prior to wiring.
Correctly connect the wiring terminals and tighten the screws.
The power supply cables and signal data lines must be separated, and cannot be laid in the same
slot or piping.
Control signal cables must be positioned away from 100V audio or power supply cables to avoid
signal interference.
Appropriate materials, such as plastic ties, must be used for all connection cables for
reinforcement to avoid looseness. When moving the cables, prevent the power supply cables from
coming in contact with the signal data cables.
Install appropriate electrical cables bushings at the cabinet opening before installing the cables in
the appliance cabinets.
Appropriate materials must be used to block the spaces reserved for the cables at the cabinet
opening if these spaces are not used.
Installing the NPM on a Fixed Surface (Optional)
If it is unnecessary to move the NPM often, embed the NPM in a fixed surface, such as a desk.
The installation steps are as follows:
1. Cut a slot for the NPM to fit in on the desk surface. The slot is required to be 198mm long and
100mm wide, as shown in Figure 2.
7