Table of Contents
Advertisement
• DO NOT position Panels or Power Supplies close to any FLAMMABLE MATERIALS while oper-
ating.
• DO NOT attempt installation and/or operation without knowledge of how to do so.
• DO NOT permit operation by persons who are not qualified to operate these types of devices.
• DO NOT shake Panels or Power Supplies, and avoid brute force when installing and/or operat-
ing.
• DO NOT apply masking or stage tape to panel surface, as doing so can result in the buildup of
sticky adhesive residue on the surface of the panels.
• DO NOT operate Panels if any of the Power Ramp or Power Supply cords have become frayed,
crimped and/or damaged. Replace any damaged Power Ramps or Power Cords as needed.
• DO NOT remove or break off the ground plug from the Power Supply power cords.
• DO NOT remove or disassemble Panels, as there are NO user serviceable parts inside.
• ALWAYS disconnect Power Supply from main power source before performing any cleaning.
• ALWAYS be sure to install Panels and Power Supplies in an area that will allow proper ventilation.
• ONLY use hardware and accessories which are listed in this guide.
• ALWAYS safely route and secure all Power Supply power cords to prevent a tripping hazard.
• ALWAYS disconnect all Power Supplies during long periods of non-use.
• ONLY use the original packaging and materials to transport these devices for service.
•
Panels and Power Supplies should be serviced by qualified service personnel when:
A. Power cords and/or plugs have become damaged.
B. Heavy objects have fallen onto them.
C. Exposed to rain and/or dampness/moisture.
D. They do not operate normally or exhibit a marked change in performance.
SAFETY INSTRUCTIONS AND GUIDELINES
7
Advertisement
Table of Contents
