Table of Contents
Advertisement
PANEL SET UP INSTRUCTIONS
7. If desired, use the Menu Display screen to configure the settings of the individual panel.(see
System Menu section on page 20).
NOTE: Due to panel orientation requirements, the Menu Display screen may not be
accessible after additional panels have been installed.
8. Each subsequent panel in the same column should attach to the Menu Display screen side of
the panel preceding it and should be oriented so that the arrows on each side of the panel point
directly away from the power supply ramps.
The installation procedure for each subsequent panel will follow steps 4 to 7 and should proceed
in the direction of power/data flow. When starting a new column, remember to begin with the
panel closest to the power supply ramp and proceed in the direction of power/data flow. See the
diagram above for reference. Continue in this manner until all panels in your system have been
installed.
CAUTION: DO NOT SLIDE PANELS INTO POSITION! THIS MAY RESULT IN
EXTENSIVE DAMAGE TO PANEL ELECTRONICS! INSTEAD, PANELS SHOULD BE
LIFTED AT THE EDGES AND LOWERED VERTICALLY INTO POSITION.
INSTALLATION INSTRUCTIONS
16
Advertisement
Table of Contents
