Table of Contents
Advertisement
PANEL SET UP INSTRUCTIONS
5. Connect a panel to any of the power supply ramps using the docking magnets, making sure that
each foot on the panel slots into the holes in the Connection Brackets. Adjust the position of the
Connection Brackets as needed to align them with the panel feet. The panel itself should be ori-
ented so that the arrows on each side of the panel are pointing directly away from the power sup-
ply ramp.
NOTE: If placed in any other orientation, the panel will NOT receive power or DMX signal. Sample
diagrams are shown on page 18.
CAUTION: DO NOT SLIDE PANELS INTO POSITION! THIS MAY RESULT IN
EXTENSIVE DAMAGE TO PANEL ELECTRONICS! INSTEAD, PANELS SHOULD BE
LIFTED AT THE EDGES AND LOWERED VERTICALLY INTO POSITION.
6. Stand on the panel to check that is it stable and does not wobble. If instability or wobbling is
detected, the panel feet may be adjusted to compensate. To adjust the feet, simply twist to alter
the height.
NOTE: Excessive wobbling or instability may lead to poor power or DMX signal connection to the
panel.
INSTALLATION INSTRUCTIONS
15
Advertisement
Table of Contents
