Table of Contents
Advertisement
SAVING SYSTEM MENU SETTINGS: After completing the steps below to configure any of the
System Menu settings, press MENU to return to the main menu selection, then continue to press the
MENU button until you have completed a full cycle through the menu options (return to Address set-
ting). This step must be completed in order to ensure that the unit remembers the changes you have
made after the power has been disconnected.
DMX Mode: Operating through a DMX controller gives the user the freedom to create their own pro-
grams tailored to their own individual needs. See the DMX Values & Functions section of this manual
for detailed information.
DMX Addressing and Channel Mode: This function will allow you to control each individual fixture's
traits with a standard DMX 512 controller.
1. To run your fixture in DMX mode, press the MENU button until "Addr" is displayed. Press ENTER
to show the current DMX address, displayed as "AXXX," where "XXX" is the current address.
2. Use the UP or DOWN buttons to select your DMX address, then double press the ENTER button.
3. Press MENU until "Addr" is displayed, indicating that you have returned to the main menu selec-
tion.
4. Use the UP and DOWN buttons to scroll to "NodE". Press ENTER to enter Channel Mode selec-
tion.
5. Use the UP or DOWN button to scroll to your desired DMX Channel Mode (CH03, CH05, CH07
and Ch10), and double press the ENTER button to select.
No DMX Setup: This mode allows the unit to default to one of four modes if the DMX signal is lost
or interrupted.
1. To select your NO DMX Mode, press the MENU button until "nodn" is displayed. Press ENTER to
configure the No DMX Mode setup.
2. Press the UP or DOWN button to select one of the four options, then press ENTER to select the
desired mode.
• BLACKOUT = "blAc". The unit will switch all LED's off if signal is lost.
• INTERNAL = "Intr". The unit will default to internal programs when the signal is lost.
• SETTING = "Sett". The unit will go to manual settings when the signal was lost.
• HOLD = "Hold". The unit will maintain the same settings as before the signal was lost.
Primary/Secondary Mode: This mode allows one panel to control one or more other panels in the
system.
1. Press the MENU button until "PRI" or "SECD" is displayed. Press the ENTER button to select the
Primary/Secondary Mode setting.
2. To run your fixture in Primary mode, press the UP or DOWN button until "PRI" is displayed, then
press the ENTER button to select Primary mode. Please note that only one panel can be set as
the "Primary" unit. All other panels in the system must be set as "Secondary" units.
3. To run your fixture in Secondary mode, press the UP or DOWN button until "SECD" is displayed,
then press the ENTER button to select Secondary mode. The "Secondary" unit(s) should now
start following the "Primary" unit.
Note: (If using multiple secondary fixtures, be sure to set additional fixtures to Secondary Mode as
well.)
SYSTEM MENU
21
Advertisement
Table of Contents
