Advertisement
WARNING! If supply trips at consumer unit, ensure correct rating of supply and appliance. If further tripping occurs consult a
‰
qualified electrician.
DO NOT use the heater with a programmer, timer or any other device that switches the heater on automatically.
8
DO NOT touch the lamps, even when cold.
8
DO NOT use the heater without the wheels fitted and locked.
8
DO NOT allow children to touch or to operate the heater.
8
DO NOT locate the heater below an electrical socket outlet.
8
DO NOT use the heater without the grille fitted.
8
DO NOT use the heater out of doors. These heaters are designed for indoor use only.
8
DO NOT use this heater if it has been dropped.
8
DO NOT use if there are visible signs of damage to the heater.
8
DO NOT cover heater when in use, and do not obstruct the air inlet and outlet grilles.
8
DO NOT place heater too close to yourself or any object, allow the air to circulate freely.
8
DO NOT touch the outlet grille of the heater during and immediately after use as it will be hot.
8
Children of less than 3 years should be kept away unless continuously supervised.
9
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in
9
its intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe
way and understand the hazards involved. Children aged from 3 years to less than 8 shall not plug in, regulate and clean the appliance or
perform user maintenance.
This appliance can be used by children aged from 8 years and above and persons with physical, sensory or mental capabilities or lack
of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
2. INTRODUCTION
Powder coated metal construction with two ceramic heating elements providing instant heat when required. Adjustable thermostat control (15°C –
45°C). Soft-touch control panel with LED display. Programmable 7-day timer function. Equipped with a tilt cutout switch for added safety. Ideal for
workshops and garages. Features chemically polished reflectors to provide maximum heat emission. Fitted with sturdy frame and carry handle.
Supplied with cable and 3-pin plug.
3. SPECIFICATION
Model no ....................................................................... CH30
Dimensions (W x D x H) ..........................395 x 387 x 668mm
Power .................................................................1400/2800W
Supply .................................................................. 230V - 13A
4. ASSEMBLY
4.1.
Fit handle and legs, refer to Parts diagram.
5. OPERATION
WARNING! Ensure you read, understand and apply the safety instructions in Section 1
‰
before using the heater.
NOTE! The ceramic element is fragile and therefore it is important that it is not subjected
to any unnecessary shocks or vibration and is not moved when it is on or until cooled down.
During relocation the heater should be switched off and disconnected from the power
supply. Ensure the heater is at least 2m from any object.
WARNING! DO NOT touch the top of the heater when in use as it becomes hot.
‰
WARNING! Always allow elements to cool before moving the units. Use only on a smooth even surface. Failure to do so will cause premature
‰
wear to the elements and reduce their working life.
5.1.
The heater has a built in tilt switch safety mechanism that switches off the unit if it is tilted beyond 25° either forwards or backwards.
This prevents fire in the event of the unit being knocked over. The heater requires manual input to restart e.g. it does not restart
automatically.
WARNING! DO NOT use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own,
‰
unless constant supervision is provided.
5.2.
Place the heater on a level floor in the area you require to heat.
5.3.
Allow a minimum of 2m between the heater and adjacent objects.
5.4.
POWER ON/OFF
5.4.1.
Connect to mains supply turn on red rocker switch.
5.4.2.
Heater is in standby screen shows 'OF'.
5.4.3.
Press
to start heater. Screen shows: week, time, ambient
temperature and power indication.
5.4.4.
Press
again heater turns off, returns to standby screen shows 'OF'.
5.5.
SETTING TEMPERATURE
5.5.1.
Default temperature at power on is 30°C.
5.5.2.
Press
or
5.5.3.
After 5 seconds screen defaults to ambient temperature.
5.5.4.
Next setting will be based on the previous set temperature.
5.5.5.
Heater will only work when ambient is lower than the set temperature.
© Jack Sealey Limited
to set temperature. One press = 1°C. Screen shows temperature only. Range is 15 to 45°C.
Original Language Version
1 Handle
2 On/off
3 Element
4 Safety guard
5 Neon indicator
6 Control panel
CH30 Issue:1 28/07/21
Advertisement
