Advertisement
DO NOT allow children or animals near the heater when in use, or whilst still hot.
8
WARNING! RISK OF ELECTRIC SHOCK. DO NOT expose the heater to water spray, rain, dripping water or wind.
‰
DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT touch the heater outlet or cone when in use, or for a period of time after it's switched off, as these are VERY hot and will
8
take time to cool down.
DO NOT switch the heater off by disconnecting it from the mains. ALWAYS set the switch on the burner to the 'OFF' position and
8
allow the cooling cycle to finish, before disconnecting from the mains.
DO NOT use an external fuel tank. Only use the tank that is fitted to the heater, and only fill it when the heater has cooled down.
8
Ensure that the heater is correctly turned off.
9
When not in use for an extended period, store in a safe, dry area, out of reach of children.
9
NOTE: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or
lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
2. INTRODUCTION
Versatile infrared multi-fuel heater designed to run on paraffin, kerosene or diesel. Clean burning unit suitable for well-ventilated applications. 15L
Tank allows approximately 8hrs running time, making this unit extremely economical. Safety features include automatic overheat safety shut-off and
quiet operation. Optional trolley available for easy manoeuvrability, Model No. IR20T.
3. SPECIFICATION
Model No ................................................................... IR20.V5
Energy Rating: .....................................................................A
Fuel Tank: ........................................................................ 15L
Fuel: ................................................Paraffin/Kerosene/Diesel
Fuse Rating: .......................................................................3A
Heated Area: ................................................14,000ft³(396m³)
Motor Power: .................................................................100W
Output: ................................................ 70,000Btu/hr(20.5kW)
Power Supply Cable Length: ............................................. 2m
Run Time per Filling (Maximum): ......................................8hr
Supply: ................................................................... 230V - 3A
4. ASSEMBLY
4.1.
Unpack the heater and check contents. Should there be any
damaged or missing parts contact your Sealey stockist immediately.
4.2.
Attach handle by lining up the holes in the handle with the holes in
the upper shell of the heater (fig.1).
4.3.
Insert screws and tighten.
4.4.
Remove heater and packaging material from the carton.
5. OPERATION
5.1.
FUELLING THE HEATER see fig.2A above.
5.1.1.
This appliance is designed to operate safely at a minimum ambient temperature of -20°C.
5.1.2.
For optimal performance of this heater, use paraffin. Paraffin has been refined to virtually eliminate contaminants, such as sulphur,
which can cause a rotten egg odor during the operation of the heater. Using diesel fuel can cause excess soot production. DO NOT use
bio-diesel as this fuel will damage your heater's seals and filter.
DO NOT use fuel such as, benzene, alcohol, white glass, camp stove fuel, paint thinners, or other oil compounds in this heater.
8
These are volatile fuels that can cause a fire or explosion.
DO NOT store paraffin in the living space. Paraffin should be stored in a well ventilated area outside the living area.
8
DO NOT store paraffin in direct sunlight or near a source of heat.
8
DO NOT use paraffin that has been stored from one season to the next. Paraffin deteriorates over time, old paraffin will not burn
8
properly in this heater.
5.2.
VENTILATION
5.2.1.
Risk of indoor air pollution and carbon monoxide poisoning. Use heater only in well ventilated areas.
5.2.2.
Always provide a fresh air opening in the heated space of at least 2,800 cm
5.2.3.
Provide a larger opening if more heaters are being used.
5.2.4.
Minimum Ventilation Opening Needed for this heater is 64cm
5.3.
STARTING THE HEATER (IGNITION)
NOTE: If air has entered the fuel line; possible when new, when left standing for a long period or when the tank level has fallen too
low, priming may be necessary. It is preferable to start the heater outdoors for the first time, to allow any oils left over from the
manufacturing process and transporting to be burnt off in a safe environment. Run it for 10 minutes on this first burn.
© Jack Sealey Limited
Although our heaters operate with
fig.2a
diesel fuel, when the temperatures
are below 0°C, diesel additives are
required to maintain the diesel's
viscosity. Typically diesel can cloud in
freezing conditions and will start to gel.
You will need additives for your fuel in
these conditions. Kerosene/Paraffin
does not start to gel until the ambient
temperature is around (-40°C).
Original Language Version
fig.1
fig.2
(3 sq. ft) for each 29 kw / hr. of heater output.
2
2
.
IR20.V5
Issue 3 (H,3,6)
19/04/23
Advertisement
