Specification - Sealey AB708.V2 Manual

2. inTRoduCTion
our range of Paraffin/Kerosene/Diesel Heaters represents excellent value. Workshop tried and tested. The range includes two economy
portable units, Model no's AB458 and AB708, which are both supplied without wheels. All except Model no. AB458 have an adjustable
thermostat (°C). Model No's AB1008 and above are fitted with digital room temperature (°C) display/error code readout and spare parts
storage compartment. Proven pump systems handle either paraffin, kerosene or diesel with only minor adjustment of air compressor. All
models are fitted with fuel tank gauge and heavy-duty fuel cap. Model No's AB1008, AB1258, AB1758 and AB2158 feature cable storage on
handle. Model No's AB7081 and above are supplied with heavy-duty pneumatic wheels.
WARninG! This heater is not suitable for use with Bio-Diesel; use of Bio-Diesel will damage the filter and seals. Damage
‰
caused by use of Bio-diesel will not be covered by warranty.

3. SPECifiCATion

ModEl
BTU/hr output (kW)
Fuel oil
Maximum operating hours
Fuel Tank Capacity (litres)
electrical Input
Power Cable (mtr)
Automatic shut off
net (Kg)
Transport wheels
Air flow (cfm)
Pump pressure PSI ±10%
Heated Volume
Consumption (litre per hour)
4. ASSEMBly
Unpack the heater and check contents. Should there be any damaged or missing parts
contact your Sealey stockist immediately.
4.1. ASSEMBlinG fRAME And WHEElS foR AB7081
4.1.1. Slide axle through wheel support frame, slide a bushing and flat washer (A) to each end of
the axle.
4.1.2. Install wheels with valve stem on the outside, slide flat washer (B) onto the axle and then
insert a cotter pin and bend the legs of the pin with pliers to secure. Snap the wheel caps
onto the flat washer (B).
4.1.3. Place heater on wheel support frame ensuring that the air inlet is by the wheels and place
the heater onto the frame lining up the holes on the fuel tank flange with holes
on the wheel support frame.
4.1.4. Place handle on fuel tank flange and line up with the wheel support frame fixing holes.
Insert bolts provided through the fuel tank flange and both frames and secure finger tight
only with nuts and washers provided.
© Jack Sealey limited
fig.1
AB7081.V2 AB708.V2
70000 (20.5) 70000 (20.5)
Paraffin / Kerosene Paraffin / Kerosene
/ diesel / diesel
9hr 9hr
19.0 19.0
230V 5A 230V 5A
2.1 2.1
Yes Yes
15.3 12.7
Yes no
240 240
4.0 4.0
13600ft³/385mtr³ 13600ft³/385mtr³
2.0 2.0
Original Language Version
fig.4
AB708.V2, AB7081.V2 Issue:8 (eRP) 12/07/19
fig.2
fig.3