Advertisement
DO NOT let power lead hang over an edge (i.e. table), or touch a hot surface, lie in the beam of heat, or run under a carpet.
8
DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT insert or allow objects to enter any openings of heater as this may cause an electric shock, fire or damage to heater.
8
DO NOT use heater if the power cord, plug or the heater is damaged, or if the heater has become wet.
8
DO NOT use the heater for any purpose other than for which it is designed.
8
DO NOT use the heater with a programmer, timer or any other device that switches the heater on automatically.
8
DO NOT touch the lamps, even when cold.
8
DO NOT use the heater without the wheels fitted and locked.
8
DO NOT use the heater without the grille fitted.
8
DO NOT use the heater out of doors. These heaters are designed for indoor use only.
8
DO NOT use if there are visible signs of damage to the heater.
8
DO NOT cover heater when in use, and do not obstruct the air inlet and outlet grilles.
8
DO NOT touch the outlet grille of the heater during and immediately after use as it will be hot.
8
Children from age 8 years and above, persons with reduced physical, sensory, or mental capabilities those with lack of experience and
9
knowledge can use the appliance, if they have been given supervision or instruction concerning use of the appliance in a safe way to
understand the hazards involved.
Children shall NOT play with the appliance.
9
Cleaning and user maintenance on the appliance shall not be made by children without supervision.
9
Children of less than 3 years should be kept away unless continuously supervised.
9
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its
9
intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate, and clean the appliance or
perform user maintenance.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a
9
hazard.
2. INTRODUCTION
Powder coated metal construction with tilting head giving directional heat control. Adjustable thermostat control (15-45°C). Soft-touch control panel
with LED display. Six programmable heat settings with shut off timer function. Equipped with a tilt cut-out switch for added safety. Fitted with two
ruby halogen infrared elements and chemically polished reflectors for maximum heat emission. Stand features easy-rolling castors with a locking
castor fitted to the rear. Suitable for a wide range of heating including restorative applications. Supplied with cable and 3-pin plug.
3. SPECIFICATION
Model No: ................................................................. IR14.V2
Dimensions (W x D x H): .........................575 x 505 x 868mm
Fuse Rating: ....................................................................13A
Plug Type: ................................................................ 3-Pin BS
Power Supply Cable Length: ......................................... 1.8m
Power ................................................................1400/ 2800W
Supply .....................................................................230V-13A
4. ASSEMBLY
4.1.
Attach the wheel sub-assemblies to the base of the heater using the bolts provided. Ensure the lockable wheels are to the rear of the
heater.
4.2.
Attach the handle to the top of the heater using the bolts provided, ensuring the shaped spacers are fitted between the heater and the
handle.
4.3.
Remove the front grille by unscrewing the retaining screws.
4.4.
Extract the lamps from the shipping carton.
WARNING! Never touch lamp glass directly with fingers, only touch the ceramic ends or use a soft cloth, otherwise elements could be
‰
damaged.
4.5.
Carefully insert each lamp into the two push-in side fittings with a gentle pressure.
4.6.
Check the lamps are properly located.
4.7.
Reassemble front grille.
5. OPERATION
WARNING! DO NOT touch the top of the heater when in use as it becomes hot.
‰
WARNING! Always allow elements to cool before moving the units. Use only on a smooth even surface. Failure to do so will cause premature
‰
wear to the lamps and reduce their working life.
WARNING! This heater is not equipped with a device to control the room temperature. DO NOT use this heater in small rooms when they
‰
are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
WARNING! Place the heater on a level floor in the area you require to heat.
‰
5.1.
Allow a minimum of 2m between the heater and adjacent objects.
5.2.
Plug the heater into the mains supply and turn on the unit using the side mounted rocker switch.
5.3.
To switch the unit off, select "0" on the rocker switch and unplug from the mains. Allow the unit to cool before handling or storage.
5.4.
The heater has a built in tilt switch safety mechanism that switches off the unit if it is tilted beyond 35° either forwards or backwards.
This prevents fire in the event of the unit being knocked over. The heater requires manual input to restart e.g. it does not restart
automatically.
© Jack Sealey Limited
Original Language Version
IR14.V2 Issue:1 10/05/23
Advertisement
