Amana AVXC20 Series Service Instructions Manual page 61

SERVICING
A U M
DVANCED SER ENUS
SUBMENU ITEM
PUMP DOWN
CHARGE MODE
SUBMENU ITEM
CL Reset
Cool Airflow Trim Hi (C TR H)
Cool Airflow Trim Int (C TR
I
Cool Airflow Trim Low (C TR L)
Cool Airflow Profile
Cool ON Delay
Cool OFF Delay
Dehumidification Select
SUBMENU ITEM
Maximum Compressor RPS Range for
Cooling (COOL RPS RANGE)
Maximum Compressor RPS Selection for
Cooling (COOL RPS SELECT)
USER MODIFIABLE OPTIONS
ON or OFF
ON or OFF
USER MODIFIABLE OPTIONS
YES or NO
15% to +15% in 3% increments
) 15% to +15% in 3% increments
15% to +15% in 3% increments
A, B, C, or D
5, 10, 20, 30 seconds
30, 60, 90, 120 seconds
ON or OFF
SET COOLING RUN VALUES (CL RUN VALUES)
USER MODIFIABLE OPTIONS
Five different compressor RPS
ranges will be provided.
10 compressor RPS values will be
provided within the range selected
in the COOL RPS RANGE menu
SYSTEM MAINTENANCE
COMMENTS
Enter PUMP DOWN Mode. This procedure runs the equipment
for approximately 15 minutes and allows accumulation of
refrigerant at the outdoor unit for purposes of removing &
replacing the indoor unit or outdoor unit.
Enter Charging Mode. This allows for a steady system
operation for a duration of approximately 1 hour to allow for
refrigerant charging of the system via the suction charge port.
The system will stop after completion.
COOL SETUP
COMMENTS
Selecting to default factory setting.
Selects the cooling airflow trim amount.
Selects the cooling airflow trim amount.
Selects the cooling airflow trim amount.
Selects the cooling airflow profile.
Selects the indoor blower ON delay.
Selects the indoor blower OFF delay.
Selecting OFF disables dehumidification; selecting ON enables
dehumidification.
COMMENTS
Select the appropriate range for the installed system
configuration.
Select the appropriate compressor RPS for the installed system
configuration.
61